This shows you the differences between two versions of the page.
Next revision | Previous revision | ||
ivac2:text [2017/06/02 17:30] ian.beswick created |
ivac2:text [2017/09/26 22:20] (current) ian.beswick |
||
---|---|---|---|
Line 4: | Line 4: | ||
* .atis <callsign> - requests the ATIS of the specified controller. | * .atis <callsign> - requests the ATIS of the specified controller. | ||
* <xxx.xxx> <message> - send a message to the COM frequency specified by the x's. //Note that you will not receive this message in your TXT IN window as you will not be tuned to that frequency!// | * <xxx.xxx> <message> - send a message to the COM frequency specified by the x's. //Note that you will not receive this message in your TXT IN window as you will not be tuned to that frequency!// | ||
+ | * .pm <callsign> <message> - sends a private message just to the specified callsign. Works even if the callsign is outside visibility range. | ||
+ | * .forward <with> <copy> - begins forwarding all text messages exchanged <with> so that a copy is automatically sent to <copy>. A warning message is sent to both parties to announce the fact that forwarding is in-progress. | ||
+ | * .xforward <with> <copy> - end forwarding of text messages. A warning message is sent to both parties to announce that forwarding has ended. | ||
* .atc <message> - sends a message to the ATC coordination channel. | * .atc <message> - sends a message to the ATC coordination channel. | ||
* .guard <message> - sends a message to the safety-com channel. | * .guard <message> - sends a message to the safety-com channel. | ||
* .wallop <message> - sends a message to all online supervisors, requesting assistance. | * .wallop <message> - sends a message to all online supervisors, requesting assistance. | ||
+ | |||
* .bc <message> - broadcast a message to all network clients [Supervisor user only]. | * .bc <message> - broadcast a message to all network clients [Supervisor user only]. | ||
* .kill <callsign> <message> - forcibly disconnect the callsign issuing the message [Supervisor use only]. | * .kill <callsign> <message> - forcibly disconnect the callsign issuing the message [Supervisor use only]. | ||
* .info <callsign> - request connection information for the callsign [Supervisor user only]. | * .info <callsign> - request connection information for the callsign [Supervisor user only]. | ||
+ | |||
+ | //The above messages may also be used in PM (personal message) dialogue, in which case the <callsign> may be left out as it will apply just to the user to whom the PM is addressed.// |