This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
ivac2:firdef_map_radial [2015/06/10 15:49] splendor.bouman [radial element] |
ivac2:firdef_map_radial [2017/05/26 10:50] (current) ian.beswick [radial element] |
||
---|---|---|---|
Line 6: | Line 6: | ||
^Element|radial|| | ^Element|radial|| | ||
^Attribute^Format^Remarks^ | ^Attribute^Format^Remarks^ | ||
- | |trk|integer|inbound track value (0-360)| | + | |trk|float|inbound track value (0-360)| |
- | |rad|integer|outbound radial value (0-360)| | + | |rad|float|outbound radial value (0-360)| |
+ | |mag|boolean|"True" or "False" to indicate whether the trk/rad values above are magnetic. Default is "False" if not supplied. IVAC2 will apply magnetic variation adjustment to bearings unless mag="True".| | ||
|len|float|length of radial to draw (in nautical miles)| | |len|float|length of radial to draw (in nautical miles)| | ||
|offset|float|offset distance in nm - start radial line from point this point| | |offset|float|offset distance in nm - start radial line from point this point| | ||
Line 38: | Line 39: | ||
<HTML> | <HTML> | ||
<p style="border:1px dashed #C11B17;color:#C11B17;"> | <p style="border:1px dashed #C11B17;color:#C11B17;"> | ||
- | Use a <b>radial</b> element to draw ILS runway extension lines | + | You should generally use TRUE bearings - magnetic variation is calculated by IVAC2. If you need to specify a magnetic bearing then ensure you set mag="true". |
</p> | </p> | ||
</HTML> | </HTML> |